1Hz-1MHz Sine/Triangle/Square Output XR2206 Adjustable Frequency Signal Generator

SKU: 1941156

6.18 5.56 Piece 5.5600000000000005 USD

¥ 44.00

Option not available

This combination does not exist.

Add to Cart

Parameters:

  • Voltage Supply: 9-12V DC Input

  • Waveforms: Square, Sine & Triangle

  • Impedance: 600 Ohm + 10%

  • Frequency: 1Hz - 1MHz

SINE WAVE

  • Amplitude: 0 - 3V at 9V DC input

  • Distortion: Less than 1% (at 1kHz)

  • Flatness: +0.05dB 1Hz - 100kHz

SQUARE WAVE

  • Amplitude: 8V (no load) at 9V DC input

  • Rise Time: Less than 50ns (at 1kHz)

  • Fall Time: Less than 30ns (at 1kHz)

  • Symmetry: Less than 5% (at 1kHz)

TRIANGLE WAVE

  • Amplitude: 0 - 3V at 9V DC input

  • Linearity: Less than 1% (up to 100kHz) 10mA

The welding installation considerations, follow these steps:

  • Welding IC socket, terminal blocks, finally power socket, adjustable potentiometer.

  • The back with a diagonal cutting pliers to cut short the pins as far as possible

  • The components are welding the front board, from low to high principles, namely the first low welding components, such as, capacitor, resistor, diode, etc.

Debugging steps:

  • After completion of welding on IC, XR2206, pay attention to the direction of IC, insert the might damage the chip!

  • check the IC whether against, such as anti please timely correction.

  • Insert the power supply, power supply for 5.5 * 2.1 port, inside outside is negative polarity. For 9-12 v power supply voltage. The waveform may not be stable for more than 12V

Using the step

  • J1 jumper cap plug in, SIN/TRI blue terminals output sine wave (note J1, J2 can only insert one of)

  • J2 jumper cap plug in, SIN/TRI blue terminals output triangular wave (note J1, J2 can only insert one of)

  • SQU blue terminals output pulse

  • AMP : Sine wave, triangle wave amplitude adjustment

  • FINE : Frequency fine adjustment

  • Coarse : Frequency of coarse adjustment

  • Schematic diagram of Function Generator